News

We are proud to announce that Trikarus is part of the regular museum area now. The special exhibition MaschinenBoom ended in december 2021 but the Hangprinter moved to a new place 30 meters far away. In the time slot from 28.02. to 04.03. i did a mass of work to revive Trikarus again because changing the place means a strict recalibration. I needed to unmount the print bed and we changed a lot of mechanical properties slighty by grabbing the frame. While checking out the machine again some bad occurences revealed additionally.

• Read more about Trikarus is part of the permanent exhibition

The last two days of public Trikarus shows generated new insights again. At 04.09. i finished the print from august and also started to print a new soap car wheel body with finer layer quality (0.5 mm instead 1mm). I did this because the last wheel body broke again and i think the layer bonding was not good enough (as one factor).

The broken wheel (finished wheel body number 2)

• Read more about Printing with fine layers and ruptured line

A week is over that quick. Yesterday was a good day!

• Read more about Another round to fight against warping